Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by scott19
-
pulley
im manufacturing a pulley for a four belt drive just wonder what the best way to go about this is using a manual lathe. roungh out v and finish wid a ground tool to the correct size. any ideas would be greatful!!- scott19
- Thread
- Replies: 4
- Forum: Mechanical engineering general discussion
