Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by SB86

  1. SB86

    Leaks during or after resin infusion

    Oh, and yes we are using a two part room cure resin.
  2. SB86

    Leaks during or after resin infusion

    Hey there, Thanks for you reply. We are using the following on top of the part: a layer of peel ply, the infusion pad (edge injection), a layer of infusion mesh, and then the vacuum bag. We can't actually see the part itself but you can see the air in the resin that sits on the top of the...
  3. SB86

    Leaks during or after resin infusion

    Hey all, I have been running into a problem for the last few months and I am in need of some advice from the forum. I am working in a production environment where we are using resin infusion. We are leak checking our parts for at least half an hour (with the actual requirement being 0"hg...
See more

Part and Inventory Search

Back
Top Bottom