@dhengr
The male part in the piston rod and female part in the mould are bayonets.These provide a positive locking."Spline" was not the correct word there.
Sorry For Late reply.I took some days off from work.
@Dhengr
The Shell is rolled and welded member.
The Top plate is welded to the shell and the hub is welded to the top plate.
The ribs are welded to the hub,Plate and the shell.The hydraulic cylinder is mounted to the hub,and its piston rod is...
I missed another two attachments.Sorryhttp://files.engineering.com/getfile.aspx?folder=6f5cc03e-c998-4e07-baf2-8da68edbaf04&file=Image-3.jpg http://files.engineering.com/getfile.aspx?folder=e82108bd-12a9-45eb-8f1f-fcc9793c6ee2&file=Image-4.jpg
@ BAretired and dhengr Thanks for replying to the post.
Iam exteremely sorry for my non informative pictures.Hope I can improve in future.
This is actually not relevant but I am a "her" not "him" and its ok that you didn't notice because my handle name is a bit foggy.
I have attached the snaps...
@BAretired Thanks for replying
I have attached the document with more detailed design that i made yesterday.Sorry for not attaching at first itself.Hope this provides more detail.
I'm still confused with the zone where there are no ribs .Is there some book for this ?.Please recommend me if...
Hi all,
This is my first post in Eng tips
This is a problem in one of my design.(please refer the snaps for details).Initially I had a thick solid plate which is now replaced with two thin plates with ribs in between them.The plate is welded to a shell which is fixed and in operation,the plate...
