Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by samya

  1. samya

    Relieving Flow rate for two systems of different design pr connected through Block and bleed valves

    We have a case where one ethylene sphere of max. operating pressure of 21.6 kg/cm2g (and Design pressure of 24.0 kg/cm2g) are connected through vapor line with an Ethane sphere of operating pressure of 11.0 kg/cm2g (Design pressure of 16.0 kg/cm2g) though double block and bleed valves along with...
  2. samya

    Raw Pyrolysis Gasolene properties from hysys simulation

    In attached file composition is given in terms of various hydrocarbons and also in terms of boiling point range. Pl. advise how to enter this kind of mixed composition in hysys. Thanks SC
  3. samya

    static charge eliminator in PVC plant screen inlet

    Can somebody pl. illustrate on the work principle of static charge eliminator used in PVC plant screen inlet ? Is there any specialized vendor available ? I have seen some steam based small equipment followed by an eductor sucking ambient air in PID. Can anybody pl. elaborate and help with...
  4. samya

    HYSYS Simulation

    Recently, while doing simulation on hysys for a hydrocracker separation section, observed that feed stream composition (End Pont of ASTM D 2887) does not match end point in final product from recycle splitter bottoms (which is the heaviest product). i.e Feed End point is lower and post...
See more

Part and Inventory Search

Back
Top