Recent content by RyanRyanRyan

Thanks for the help. Still quite confusing, but that is Catia for ya I guess. You would think you could just click sectioning icon, cut through a plane, and use curves....this catia is so confusing. Anyway, thanks again. Ryan Hill Design Engineer bestCADsolutions, Inc.

When I use the sectioning tool in a CATProduct, the section window pops up with the geometry from where the section goes through, but I can't seem to then do anything with the section. I need to be able to project those entities onto a surface or even make them visible. When I click ok, the...

Thank You Ryan Hill Design Engineer bestCADsolutions, Inc.

How do you cut a section through a part?? Ryan Hill Design Engineer bestCADsolutions, Inc.

thanks again. much better on my eyes now :) Ryan Hill Design Engineer bestCADsolutions, Inc.

Somehow I made my tree get really small. Almost to the point where I can barely read it. Can someone tell me how to size it back up? thanks. Ryan Hill Design Engineer bestCADsolutions, Inc.

thank you all for you help. I have dug into it a bit more and found some stuff out. Thanks Ryan Hill Design Engineer bestCADsolutions, Inc.

How do you cut a section through a CATProduct??? Ryan Hill Design Engineer bestCADsolutions, Inc.

I am using V5R17. When working in a CATProduct, I can't seem to figure out how to work on the piece parts within the assembly. I have been going into the piece part, changing what I need and then it updates the assembly. Is there a way I can do the work in the CATProduct? Also/Or Is there a way...

The only thing I know about the runtime error, is that it happened to me. I believe it was because my computer didn't have the power needed to run the program (RAM, GRAPHICS CARD,HARD DRIVE, ECT). You may need to upgrade your computer before being able to do much with CATIA. Good luck. Ryan...

yea F3, figured others would have known already :) Ryan Hill Design Engineer bestCADsolutions, Inc.

Nevermind, Nevermind. Figured it out. Ryan Hill Design Engineer bestCADsolutions, Inc.

I was working normally in V5 drafting, and I hit something and now my navigation window on the left of screen (where it shows sheets and views ect.) has disappeared. I cant seem to figure out how to get it back...any suggestions? Ryan Hill Design Engineer bestCADsolutions, Inc.

hey thank you very much, the more help the marrier! Ryan Hill Design Engineer bestCADsolutions, Inc.

Ferdo, again...coming through for me. haha. Thanks alot. Ryan Hill Design Engineer bestCADsolutions, Inc.