Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Ryan95
-
Hydraulic and Pneumatic Sealing in Shock Absorber
Hi, Dave and Ted Thank you very much for your feedback. Would a better design for the floating separator piston be a simple disc with a single groove for a piston seal on the OD, and a single groove for the rod seal on the ID? This, instead of having 2 rod seals (sealing in both directions)...- Ryan95
- Post #4
- Forum: Mechanical engineering general discussion
-
Hydraulic and Pneumatic Sealing in Shock Absorber
Good day, I am a junior aeronautical design engineer working on an oleopneumatic shock absorber for aircraft landing gear. I've attached a simple diagram (omits a lot of detail so that only what I am referring to is shown) to the post to show the layout of the problem. The shock absorber...- Ryan95
- Thread
- Replies: 6
- Forum: Mechanical engineering general discussion
