I didn't think that this would be the case but just needed another opinion. Here is my reasoning. When the molten material makes contact with the colder mold surface, it may cause the material in direct contact to solidify faster than the core or center of the now new part. Is this enough of a...
I have a cast part with some machined surfaces. Is the act of machining the part, other than the obvious removal of material, weakening this area. Is there some kind of surface hardening that has taken place during the simple pour operation? I know there isn't much information but I am just...
What is the correct way to call out a thread for the inside of a bored hole and it's threaded mate. I need to join two components with a fully threaded stud. The hole in the mating parts is 2 inches inside dia. Or is there a std straight thread that I can use?
Do I use the pitch diameter as the...
Does anyone have a simple equation to calculate the steady state temperature inside a box knowing the insulation qualities of the box, the initial temp, surrounding temp as well as the heating source?
I am trying to do a rough calculation on what temperature will be achieved inside this sealed...
