Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by rsplante

  1. rsplante

    NX8 not generating JT File

    It is administratively locked in the on position. When saving the file, I receive the message that it is saving JT Data, but nothing shows up in Teamcenter.
  2. rsplante

    NX8 not generating JT File

    I'm using NX 8.0.3.4 with Teamcenter 8(8.3.2.3_b01_1(20130730.00) and when I save a part file, it says that it is saving JT Data; however, when I open the model file (m) there is no JT File there. I have tried refreshing, and have restarted Teamcenter. Another user opens my model in NX and...
  3. rsplante

    NX6- Revolve closed loop

    Partly, I used this as a learning opportunity. Secondly, I expected to be able to knock it out in an hour (ha). I have gained a better understanding of using the Mesh tool, and have figured out some things about Revolve. Not that it has anything to do with creating it, but it is far from a...
  4. rsplante

    NX6- Revolve closed loop

    I finally got it to work. Still not sure how. Partly, it made a difference when I set it to an interference fit. When I made the revolve all by itself, it worked immediately. Getting it to wrap around another part, it would appear correctly but transparent. When I hit OK, it disappeared and...
  5. rsplante

    NX6- Revolve closed loop

    Help - I am new to NX6, I created a fully constrained closed loop in a sketch, I attempted to revolve it around a line, and was told that it had to be within -360 to plus 360 degrees and that it was more than 360 even though I specified 360. Eventually it dropped that message (after multiple...
See more

Part and Inventory Search

Back
Top