Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by rsirianne

  1. rsirianne

    Drawing Section View Error Message

    Thanks for your response. I guess my 2004 was somehow corrupt. I installed 2005 last night along with SP.01, and the problem went away.
  2. rsirianne

    Drawing Section View Error Message

    Scott, Sorry, I'm new to the site and I didn't give you enough information. It's a standard, run of the mill SW 2004 solid (sp 4.0), with no alerts, flags, or unresolved features, created the old-fashioned way. Nothing special or complicated about it. Actually I'm having the same problem with...
  3. rsirianne

    Drawing Section View Error Message

    Scott, It is a solid. I've seen this once before and somehow I got around it but it was a while ago and I didn't make a note of it. Ray
  4. rsirianne

    Drawing Section View Error Message

    I've done a lots of section views in drawing mode before, but today when I click on the "create section view" icon I immediately get an error message that says "there are no drawing views from which a section can be made". This happens regardless of which view in the drawing I activate. Any...
See more

Part and Inventory Search

Back
Top