I checked the FAQ's and Scott's site, I'm looking for any more tips before I try a multiple install of 2005 0.0 over my 2004 3.1. I've read Scott's tip on renaming the directory, is that all? I'm a little leary, my new employer's IT folks are not as supportive as my past home. The install is...
All of these posts are sage advice and you would be wise to heed them all!! I have been openly critical of the inclusion of Cosmos Express in the last several releases of SolidWorks. I won't bore everyone with my reasons again, but suffice it to say I have witnessed good "rule of thumb"...
Creech;
Not to speak for Scott, but I think he intended you to go to the web site he gave you and review the different packages offered, decide which one suits your needs and skill level. If you do this and report your findings here there are individuals that will give you approximate pricing...
I think this falls into the category of "push button modeling". We will always be required to use some thought and a few commands to create our part geometry. There are most times numerous methods to achieve the same result, use the one that "fits" your thought process best. If you do a lot...
