Thanks Mike.
I was aware of this site, but feel it is too big a risk to buy their CD rom (with all the drivers I don't need just to get the one I do), at a substatial cost ($199.00) -- then possibly find it still doesn't get the device working.
Even though it is a great plotter, it is so old...
I have a Hellett Packard HP7550a plotter. This is a very good and precise plotter.
But it seems HP no longer supports it, and I can't find a Winndows 98 print driver for it.
Does anyone have one and/or is there a print driver available??
Thanks in advance.
Perfect...
Right, kilopascals it is, I should have been clearer on that point.
I just wanted to make sure the conversion factor was acceptable.
i.e 2700 psf = 129.28 KPa.
Thanks so much!!
Hello, I hope I have found the right forum.
I have a project that requires addition of metric values to a set of standards now shown in U.S. only (they will now show dual units).
I am not an engineer, but have construction and technical background.
I am somewhat confused as to the proper...
I am performing a project that requires addition of metric measurements to standards that now are all US.
The concrete mix designs are per AISC greenbook - in the form:
520-C-2500 (520=lb cement "c"=aggrgate size 2500=psi).
The new designation will be metric in the form (I found...
I apologize if this question has been asked previously. There are so many hits on metric, it is overwhelming.
I have a project where I have to add metric units to drawings that already contain US. But, in most cases, the measurements were placed as text, not as a calculated dimension.
Is...
