Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by RRdesigner
-
NX3 Routing Defaults
We are using NX3 and Routing Mechanical. I have managed to adjust almost all preference setting for start-up. But one setting is missing. That is: How to set the default discipline ? The default discipline seems to be Piping, but we are using only Tubing. This preference can be changed from...- RRdesigner
- Thread
- Replies: 0
- Forum: Siemens: UG/NX
-
Reference sets and drawings
. I have an assembly containing several reference sets. These reference sets are so-called configurations. I would like to make one drawing for one configuration. Is there any way to do this job? (The assembly is quite large: over 100 parts and 8 reference sets.) . .- RRdesigner
- Thread
- Replies: 2
- Forum: Siemens: UG/NX
