Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by roywu2002

  1. roywu2002

    Dimensional tolerance MIN question

    Ah that makes sense. Thanks a lot guys!
  2. roywu2002

    Dimensional tolerance MIN question

    If a drawing has specified the following: UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN INCHES DECIMAL TOLERANCES .X +/- .1 .XX +/- .010 .XXX +/- .005 .XXXX +/- .0005 FRACTIONAL TOLERANCES +/- 1/16 ANGULAR TOLERANCES +/- 1 deg FILLET RADII .005 MAX And there's a...
  3. roywu2002

    Can you use true position on planar feature of size?

    SeasonLee: That's exactly what I was asking for. That was very helpful. Your post led me to look up TOP. I'm an entry mechanical engineer so I still have a lot to learn. Thank you so much! Really appreciate your help. Roy
  4. roywu2002

    Can you use true position on planar feature of size?

    Can you use true position on planar feature of size? If so, please give me an example! Thank you very much!
See more

Part and Inventory Search

Back
Top Bottom