The result of the two may be some diff but the fold of the simulated rubber still look the same so it still OK.
So what i want to find out is the use of diff Poisson's on the simulation have on 2D & 3D. What are the best/right Poisson's to use for 2D & 3D simulation.
If you would like to try...
Hi GBor
It should be appropriate for 2D.
As what i understand, result for simulation done in 2D will be for per unit. So what i have done is to use the same cross-section for both the 2D and 3D. The 3D is also set to 1m lenght(as per unit in 2D), which mean the result should be or close to be...
Hi All
I have been using abaqus to do simulation on rectangle rubber block compression till buckling(high deformation) and are having some difference in result.
1)by using default Poisson ratio in abaqus(0.475),
for a 3D simulation result seens OK but when done in 2D, the rubber will...
