Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by RotorChef
-
Resin Infusion Voids
Thank you for the reply. Would you suggest that after part is infused, we lower the vacuum to evacuate excess air/resin immediately? We are pulling somewhere around 26" during the infusion which takes about 8-10 minutes. The heat is then ramped up to 100c from 50 at this point. With the heat...- RotorChef
- Post #5
- Forum: Composite engineering
-
Resin Infusion Voids
Hello all, I am new to this forum and am excited to learn from the wealth of knowledge and experience from all of the members. I did some searching and found some similar issues regarding voids in my laminates while using VARTM methods. I am using a sizeable aluminum mold that has a computer...- RotorChef
- Thread
- Replies: 6
- Forum: Composite engineering
