Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by rosshollands

  1. rosshollands

    Coupling Two Shafts

    Thanks to you all for your suggestions. I've gone for the lovejoy coupling. Thanks again. Ross
  2. rosshollands

    Coupling Two Shafts

    Thanks for your help - I'll check those out... Cheers Ross
  3. rosshollands

    Coupling Two Shafts

    No unfortunately not...
  4. rosshollands

    Coupling Two Shafts

    Hello to you both, Thanks for your suggections. Unfortunately we are stuck with what we have (servo and encoder). This is an R&D project and we have to use existing parts laying around the factory! I like the sound of spur gears though....are these accurate enough for precise positioning...
  5. rosshollands

    Coupling Two Shafts

    Dear All, Hope you may be able to offer some suggetions. I have a servo motor with a 19mm OD shaft. I need to couple it with a 25mm OD shaft. No problem here I can used a stepped coupling. Further up the 25mm shaft I have a timing pulley which is linked to an encoder via a 10mm timing belt...
See more

Part and Inventory Search

Back
Top Bottom