Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Rooster35236
-
Proper Bearing Selection
Cost is not huge restriction at this point, once the prototype is finalized we are going to need thousands for full production.- Rooster35236
- Post #3
- Forum: Bearing design, manufacture and maintenance
-
Proper Bearing Selection
This is my first post here! I have been working on product development for a customer and because of the NDA there isn't a whole lot I can say about it but the project needs a specific bearing. It must have an eccentric locking collar which would accept roughly a 1/2" bore, originally we went...- Rooster35236
- Thread
- Replies: 6
- Forum: Bearing design, manufacture and maintenance
