Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Ronthewood
-
Roller material to run on aluminium
Hi and thanks, Ok, I'll go with polyurethane, but I think I'll leave the casting method up to you experts for the time being, I've seen a few rollers online which are about the right size. Does it machine on a lathe OK? Skate wheel, good idea, presumably these are also made from polyurethane...- Ronthewood
- Post #3
- Forum: Composite engineering
-
Roller material to run on aluminium
Hi, My job is not in engineering, I'm actually a furniture maker and I'm stuck, and I hope you knowledgeable folk can help me out. All the wood I use comes from within a 5 mile radius, I buy the trunks from local landowners/forestry, sawmill it, dry it and then make domestic furniture. My...- Ronthewood
- Thread
- Replies: 4
- Forum: Composite engineering
