Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by RonNicholls
-
Number of Decimal Places for tolerancing (Metric vs Inch)
Trying to dimension a print properly and came across an intriguing portion of the ASME Y14.5-2009 standard. I have always understood that if you use (for example) 3 decimal places in the "nominal" dimension, then the "tolerance" should have the same number of decimal places (example: 33.3"...- RonNicholls
- Thread
- Replies: 5
- Forum: Drafting Standards, GD&T & Tolerance Analysis
