Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Roche1380

  1. Roche1380

    CONTROLS command problem

    Dear All, I'm dealing with Controls command in my input file. Currently I have: *CONTROLS,PARAMETERS=FIELD,FIELD=DISPLACEMENT .02,.5,,,0.04 *CONTROLS,PARAMETERS=TIME INCREMENTATION 1500,1500,200,1500,100 when I have it, there is no result. when I remove it I get the curves I want but it...
  2. Roche1380

    ABAQUS does not consider my B.Cs from the Input file

    Dear all, I have an UEL and I'm using an input file to address the material and geometry properties. But when I see the results it seems ABAQUS has not addressed the defined BCs and some of BC nodes are free. Here are my command lines: *BOUNDARY, TYPE=DISP Clamp-up,ENCASTRE Sym-Left, XSYMM...
See more

Part and Inventory Search

Back
Top Bottom