Recent content by ROBERTDAY

Sounds like you have a good workable idea. What about using one PID loop and just changing the SP for different situations?

If anyone is using AutoCAD Electrical 2004 or VIA WD they may be familiar with the "INSERT RULED TABLE: import comma-delimited file and insert as ruled table" function. I have a block of a VFD that I use quite often and I always list the drive setup parameters on the drawing. Typically...

I recently ran across these neat little guys. http://www.tri-plc.com/t100md.htm They look like they may be useful in your application. They have a built in LCD display and are low profile. They also look like they have serial comms. I don’t know much more about them but I have requested some...

I know some one who may be willing to help you. Go to http://www.plctalk.net and post the same question. Hope this helps you.