Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by rkdpv

  1. rkdpv

    Circ. Stress at Horn of Saddle

    Thanks Tom Very informative.
  2. rkdpv

    M.A.P.NC is Governed by a Flange !

    jt I am using ASME sec. VIII div 1. and flanges are standard ASME B 16.5. Thanks
  3. rkdpv

    Circ. Stress at Horn of Saddle

    How can the Circ. Stress at Horn of Saddle be reduced? Actual= 227.41 MPa Allowable= 135.31 MPa Otherthings are fine. Shell length= 15 m Shell Dia= 3 m Thanks n Regards
  4. rkdpv

    M.A.P.NC is Governed by a Flange !

    Thanks all.. Jt: thanks, good option, can we set hydrotest pressure based on the next limiting component? Is this permitted in ASME code? Regards
  5. rkdpv

    M.A.P.NC is Governed by a Flange !

    What should we do when MAPNC is governed by a standrad flange. Why mawap or mapnc should not governed by flange and what should we do in that case? Regards
  6. rkdpv

    Material of Construction for -46 deg C

    Hello Design Conditions: Design Temperature: 65 C/-46 C Design Pressure : 20 Kg/cm2 and Full Vacume Service: Propane Please suggest whether we can use SA 516 Gr 55 or not. Please suggest any other cost effective material for this condition. Thanks in advance
See more

Part and Inventory Search

Back
Top Bottom