Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by RJT1130
-
removal of Timken 798DE bearing
There were no collars, just a light press on a sleeve which was a light press fit on the shaft. No idea why there were spanner wrench holes in it. We were able to break it loose with the wrenches we made and tap the end of the shaft to remove it.- RJT1130
- Post #2
- Forum: Bearing design, manufacture and maintenance
-
removal of Timken 798DE bearing
New member, not sure where to post this, move it if there is a more appropriate place. Customer with a 50 year old piece of equipment, need to remove this bearing to repair the equipment. Looks like I need 2 spanner wrenches to remove collars, then pull it off with a huge bearing puller? Am I...- RJT1130
- Thread
- Replies: 3
- Forum: Bearing design, manufacture and maintenance
