Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by rjim

  1. rjim

    Weld Thickness

    Ron, If you had to install 6- W8by31(8"by8")wide flange beams 7'long to side supports of 1/2 steel, running consecutively 3'apart with a load of 50,000lbs on them. How would you calculate this? How much weld should go into welding these flanges? Thanks, Jim
  2. rjim

    Weld thickness

    Ron, If you had to install 6- W8by31(8"by8")wide flange beams 7'long to side supports of 1/2 steel, running consecutively 3'apart with a load of 50,000lbs on them. How would you calculate this? How much weld should go into welding these flanges? Thanks, Jim
  3. rjim

    Weld thickness

    Looking for information on how to calculate the amount of weld that has to go into certain steel. I know most calculations have to cover the steel composition, load and so on. I am a welder by trade and would like to know how to figure this process.
See more

Part and Inventory Search

Back
Top Bottom