Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by rivtim

  1. rivtim

    FR10 equivalent

    rharr, I have recently purchased the "Worldwide guide" recommended by Corypad. It so far has been an excellent reference book that is quite easy to navigate. I can't comment on Stahlschlüssel as I have not yet seen that book.
  2. rivtim

    FR10 equivalent

    Thanks Cory, Most of the time, my customer is in the same boat that I am. They are given a rush RFQ with prints and specifications in another language and no supporting documentation. I try to offer them an available substitute but make it very clear that we do not guarantee that substitute...
  3. rivtim

    FR10 equivalent

    I have a print specifying FR10 for a cold headed part. I am looking for the SAE or ANSI equivalent to FR10.
  4. rivtim

    TSG 3290

    I was unable to resolve this issue. I deferred the problem back to my customer and have not recieved a response. I am assuming that something was copied in error.
  5. rivtim

    TSG 3290

    I am looking for an sae material equivalent to a Toyota material spec TSG 3290.
  6. rivtim

    Ferritic Nitrocarburizing to PS 4-T

    Does anyone have the Chrysler spec for ferritic nitrocarburizing to PS 4-T.
  7. rivtim

    Press Fit Pin, Ballout of 2 Ends using 1 Hyd. 100 Ton Press

    It sounds to me like you are looking for a cotter pin. If that isn't strong enough and you need to go solid, as long as there is clearance you can use a solid rivet and an end cap. Either way you should be able to get these items off the shelve from a fastener supply house.
  8. rivtim

    MS 5479, PS 6151a and PS 7099

    I am quoting a threaded stud with these specifications. Any information would be appreciated.
  9. rivtim

    ASTM A749/A749MM

    I have a callout on a print for "material must conform to ASTM A749/A749m". I am quoting a rivet from an assembly drawing that specifies the same material for the plate steel and the rivet. I am unable to find any info on this astm spec.
  10. rivtim

    MS 573

    I have a limited conversion table for Chrysler steel specs that doesn't include MS 573. Can anyone tell me the SAE equivalent?
  11. rivtim

    SAE 1139

    Thanks for the input folks! You are both right. I am cold forming but apparently the previous supplier was screw machining and hardening. My customer wasn't aware of the hardening requirement and subsequently is backpedalling now. I am offering 1541 due to the higher mangenese content.
  12. rivtim

    SAE 1139

    I am looking for any information I can get on SAE 1139. Our customer is looking to change a part we currently make from SAE 1018 to SAE 1139.
  13. rivtim

    alloy steel

    I am looking for a North American equivalent alloy steel to European standard 35B2 EN 10269.
  14. rivtim

    TSG3210G SMn40

    I am looking for the North American equivalent to this Toyota Spec. It is most likely some form of low cabon steel.
  15. rivtim

    Din 17111

    I am looking for an SAE equivalent material to USt 36 Din 17111. The product is a rivet for a Volkswagen. Normally we are looking at C1010 but I'd like some sort of confirmation of this.
See more

Part and Inventory Search

Back
Top