the best that I have done so far was to assemble the compnents at same time, and since the constraining hole was a pattern, it put in most.
the assembly stack method sounds interesting, I will investigate this method a little further. not sure what is meant by a subnode or not.
Hi all,
I have been running Nx 7.5 for a few month now, Nx 6 before that.
My question is as follows. we have been adding hardware, nuts, bolts, washers. etc. This is very time consuming. I was wondering if Nx had another way to add all the components as a group of components, I don't want...
