So here's my situation, I have A182-316/316L material welded with a WPS for P8 to P8 and F6/F5 and A# A8. The rods used were ER316L and E316L-xx.
When the weld cap is scanned with XRF spectrometer what material specification should the Cr, Ni, and Mo results be within, Sec 2 C or Sec 9 A8...
Yes, it's to verify the welding rod used.
I'm just wondering also, how much will the dilution from the parent material effect the analysis of the weld?
This may be a basic question but, I am fairly new to welding chemical analysis.
I am using an XRF spectrometer to measure weld deposit on a 3/4" NPS A182-TP316L socket weld (as per client specs).
I am wondering what code and table the analysis should conform to.
Section II Part A is for Pipe...
