Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by RickRST
-
Getting it made
Thanks for the replies. Freddy, yes as an Electrical engineer I don't know the ins and outs of manufacuring. My first thoughts were I didn't want to deisgn something that would be ridiculously expensive when it needn't be with a few simple changes. Are there people on these forums that would...- RickRST
- Post #6
- Forum: DASSAULT: SOLIDWORKS 3D Design
-
Getting it made
Hi all, first post on the forum. I'm currently learning solidworks with a view to designing some very simple parts. Currently i'm looking at a flange and a thermostat housing. I imagine these to be made from billet aluminium. I want to know if i'm wasting my time, if one offs or very small...- RickRST
- Thread
- Replies: 10
- Forum: DASSAULT: SOLIDWORKS 3D Design
