Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by RickDM
-
Hot Tapping / Cutting 304H Stainless Steel at Elevated Temps 700F+
We are looking to hot tap / cut a 14.75" diameter hole in 304H SS flat material (7/8" thick) that is operating at 700F-1000F. We are using a 400F steam purge on the cutter side of the blind flange to cool. We have attempted several mock-ups to fine tune the procedure before going to...- RickDM
- Thread
- Replies: 0
- Forum: Material engineering general discussion
