Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by rich99

  1. rich99

    Looking for an Old Versions of ASME code

    Thank you for your reply. I contacted the person at ASME who told me about PFT-34 and he sent a PDF of this page. It does not appear this will help. Thank you for the advice.
  2. rich99

    Looking for an Old Versions of ASME code

    I asked ASME, where I could find out about the acceptable design of reinforced flat, rectangular plates with gussets. I was told the design of gusset stays was addressed in the 1971 edition of Section I, PFT-34. Can anyone provide the actual wording of this removed section of the code or a...
  3. rich99

    ASME Section I, IV or VIII Software recommendations?

    There are several commercial products relating to ASME Section VIII, division 2 software (CodeCalc, Compress, etc.). Could anyone recommend any of them? I'm interested in code calculations as well as design optimization software for asme sections I, IV and VIII. Thank you for any...
See more

Part and Inventory Search

Back
Top Bottom