Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by ricbus
-
SAP2000 API MatLab - Setting restraints
Hi Ushaann NET.explicitCast refers to Visual Basic, therefore it does not run. Remove it. Regards RB- ricbus
- Post #5
- Forum: Computers and Structures: SAP2000
-
SAP2000 API MatLab - Setting restraints
hi! Mathias Try this: PointName1 = ' '; PointName2 = ' '; Restraint = logical(zeros(6,1)); for i = 1 : 6 Restraint(i,1) = true(); end [ret, PointName1, PointName2] = SapModel.FrameObj.GetPoints('K1', PointName1, PointName2); ret = SapModel.PointObj.SetRestraint(PointName1, Restraint); Regards- ricbus
- Post #2
- Forum: Computers and Structures: SAP2000
-
SAP2000 API using MATLAB // SapModel.DesignSteel.GetSummaryResults
hi! Has anyone used the command SapModel.DesignSteel.GetSummaryResults ? I'm running linear TH and after running the analysis and using the design tool (ret = SapModel.Analyze.RunAnalysis; ret = SapModel.DesignSteel.StartDesign;), everything works, but to set the output to obtain the data...- ricbus
- Thread
- Replies: 0
- Forum: Computers and Structures: SAP2000
