Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Revngeofrobo
-
Balancing Warp and Weft Face
We are using a 8HS 7781 fabric with a thermoplastic matrix. Layup 1, 8 ply [45/-45]2S Layup 2, 10 ply All [0]s I think my confusion is with the definition of warp and weft. I'm reading the warp is along roll direction of the fabric and weft or fill is along the width of the fabric. My...- Revngeofrobo
- Post #3
- Forum: Composite engineering
-
Balancing Warp and Weft Face
Hello all, I know it is good practice to balance your laminate orientation angle by making a systematic laminate about an axis. My question is around warp and weft balancing of a weaved fabric. Is it good practice to go: up/up/up/down/down/down or should you balance them in the same way a...- Revngeofrobo
- Thread
- Replies: 6
- Forum: Composite engineering
