Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by RetroK
-
ASME VIII Div 1 Appendix 13
Lets update my post of 17 Feb 16 Re tigy post 2007 on ASME VIII Div 1 Appendix 13 Should read tigny Hope this has not caused to much confusion! I'm thinking Dividers On vessel centreline are worst case, so placing off centre would give conservative results by code formulae?- RetroK
- Post #2
- Forum: ASME (mechanical) Code Issues
-
ASME VIII Div 1 Appendix 13
Re tigy post 2007 on ASME VIII Div 1 Appendix 13 :- Circular vessel with diametrical staying member. Also spreadsheet pdf on calculation sheet Rev 000c Can anyone suggest modifications to formulae that would satisfy code approval and acceptance of thicknesses chosen, where A)Divider plate is...- RetroK
- Thread
- Replies: 1
- Forum: ASME (mechanical) Code Issues
