Recent content by rep001

Sorry Sam, tried that but not sure how it would work. REM: im trying "TO PLACE A ORDINATE DIMENSION INTO A DETAIL VIEW WITH THE ORIGIN OUTSIDE OF THE DETAIL VIEW" Can you show me in a PDF? REP

The part I'm making is much more complex than what is shown in the PDF. Making the Section view is the important part. My customer is requesting it. I have seen it done in NX from another designer, so I know it can be done. Thanks for your input. REP

I need to learn how to make a section at an angle. my arrows alway end up perpendictular to the cut plane and I want the another angle(22degree). the attached PDF shows the basics for what I need. REP NX5

correction its not an i, its a j!!!!!!! (pe y j all x) works much better when you "JOIN" lones. HA Have fun REP

I made mine. custom button called "PE LOOP" Disc: for making a pline loop from singles lines macro is written as (pe y i all x)spaces ar important. to use it: select one of the lines you want polylined and then the ICON. it joins all the lines that are at endpoints. works most of the time for...

OOPS! IV PRO 2010 REP

CAN SOMEONE TELL ME HOW TO PLACE A ORDINATE DIMENSION INTO A DETAIL VIEW WITH THE ORIGIN OUTSIDE OF THE DETAIL VIEW? THANKS REP

Is there a way in NX5 to mak a fillet that is tangent on one side, and sharp on another? some sort of setback option? ie; my fillet surface is 1" and my filler radii is 3". Cant sweep the area. Thanks Robert Your file's link is...

Using NX4, Drafting, Model messures .0625, drawing shows .062 if 3 place and .0625 if 4 place. It should round up to .063. dose anyone know why this is happening or a setting to check. Thanks Robert If this has already been posted, sorry, I cant serch from my browser.

Another way is to use the utility symbol/ intersection, to make a point where the two edges would meet/cross. then, you can use that point and the origin.

It was the WAVE Geo linker. linked geo was turned off by another employee. thanks for the lesson. Robert

My part number in the windows border shows as: xxxxx.prt (!) I know there is a problem but I dont know why or what it is. NX-4, Win XP, standard part with imported file.

can anyone who writes LSP, add DDEDIT into tedit.lsp. I wish I knew lsp, I would do it. Thnks

When editing a geometric tolerancing it defaults to the properties diolog box. Is there a way to set autocad to open the geometric tolerancing dialog box when you double click it? mine opens the Properties diolog box and I have to scrole to the OVERRIDE area and click the diolog opener. Thanks...

Thanks boldfish, and all the other. I followed the instructions to the letter and it failed!!! Then I did it again and it worked fine. just what I needed. It was my fault: REMEMBER no spaces or funny charicters in the name. on a side note: I did a search on here (eng-tips) and nothing came up...