Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by RENHELL
-
Problems with finding a small "high pressure", "Non plastic"
Pulsation is not a consern.. We are currently building our own two stroke diesel engine for entering in the Shell Eco marathon. The sought pump is intended to pressurize the "secondary" fuel system(the circuit just behind the solenoid injector nozzle) and with a relieve valve controled "bypass"...- RENHELL
- Post #7
- Forum: Pump engineering
-
Problems with finding a small "high pressure", "Non plastic"
Great Idea..Bosch are reluctant to hand over too much information on specs, though.. But again, thank you..- RENHELL
- Post #3
- Forum: Pump engineering
-
Problems with finding a small "high pressure", "Non plastic"
I am currently involved in a project at DTU (poly tech Uni, Denmark) where i am in dire need for a small(physically) all metal pump, delivering pressures up to 100 Bar with no particular requirements regarding flowrate (very small). The pump MUST be relatively free of Rubber/plastic componets...- RENHELL
- Thread
- Replies: 9
- Forum: Pump engineering
