Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Refurb1950
-
CO2 gas regulator
Zeusfaber, I have examined under low power magnification the oring. No damage is visible, but I am not ruling it out. I chose 90 durometer urethane for the seat as I did want something that was slightly conformal, but that would be tough enough to withstand the cold temps. Any other suggestions...- Refurb1950
- Post #4
- Forum: Gas compression engineering
-
CO2 gas regulator
I have been designing and prototyping a small pressure regulator to handle CO2 from standard small gas cartridges. The regulator is made of GF nylon 6/6 and is currently of the balance piston style. I am looking to regulate the 850 psi cartridge pressure to values between 5 and 40 psi. I seem...- Refurb1950
- Thread
- Replies: 3
- Forum: Gas compression engineering
