Recent content by redwanamit034

Hello, I am simulating heating of a copper wire with laser welding. I am using a uncoupled heat transfer model for this purpose. As I am applying very high heat flux, the temperature goes up instantly. When I don't define melting. there is no problem with the model. However, when I defined...

One more thing. The property will vary with temperature as well. I defined that change of conductivity,density with temperature. But i don't know how can i define the change of material property with time as well

I am quite new in abaqus. Can you tell me how can I define a material whose properties will vary with time? The materials property is dependent porosity. I have data for change in porosity with time. Now the conductivity,density will change with porosity. How can I do that? Please help

I get this warning message when I am doing some static coupled thermal-electrical-structural analysis and the simulation doesn't run saying too mant attempts made for this steps. "16 elements are distorted. Either the isoparametric angles are out of the suggested limits or the triangular or...

I need to find the Heat flux due to electric current for the entire geometry. Any suggestions?

I am doing coupled temperature-electrical analysis for Spark Plasma Sintering using ABAQUS. I requested for Heat flux due to electric current (SJD) in the field output request. But, I can only get the Heat flux due to electric current (SJD) at the contact surfaces. How can I get the SJD...

I need to model sintering of Fe based amorphous ribbons coated with Cu/Ni . The ribbon is about 25 micron and coatings are 5-10 micron. There will be 20 layers of this ribbon coated with Cu/Ni stacked together. What type of element should I use for ribbons and coating? And how do I define the...

I need to model sintering of Fe based amorphous ribbons coated with Cu/Ni . The ribbon is about 25 micron and coatings are 5-10 micron. There will be 20 layers of this ribbon coated with Cu/Ni stacked together. What type of element should I use for ribbons and coating?

I am making a coupled temperature-electrical-structural model for Spark Plasma Sintering. I have used abaqus standard. The model worked for simple geometry involving only 3 parts (2 punch and die), but it is not converging for my original model which has 2 punch, sample, die, 4 spacers. I used...

here is the message filehttp://files.engineering.com/getfile.aspx?folder=b28246be-9508-471d-8077-4bc7682c227e&file=Job-3_MSG_FILE.msg

I am making a coupled temperature-electrical-structural model for Spark Plasma Sintering. I have used abaqus standard. The model worked for simple geometry involving only 3 parts (2 punch and die), but it is not converging for my original model which has 2 punch, sample, die, 4 spacers. The...

ya these are warning. the model didn't converge. the error message was- "too many attempts made for this increment"

I am making a coupled temperature-electrical-structural model for Spark Plasma Sintering. I have used abaqus standard. I did a coupled temperature-electrical model beforehand and it worked well. But the new 3 way coupling model is showing too many errors.- 1. SURFACE INTERACTION horizontal...

My materials properties (Conductivity) will be dependent on density. How can I incorporate this feature?

how can I couple nodes so that they have the same voltage?