Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by rdhdesign

  1. rdhdesign

    INSERTING ACTUAL PART SIZE IN BOM

    Hi Sirius2, Thanks for your input on the BOM software but it appears that it only works with Boolean Solids and not Parametrics. I will look into it farther though. As far as using Mechanical Desktop for Die Design I am very impressed with it. It takes a little more time to do the...
  2. rdhdesign

    INSERTING ACTUAL PART SIZE IN BOM

    Pat, Thanks for the info and I'll see if that will work for me. I was hoping that since MDT can figure mass, it already knows how large the detail is, and that I could retrieve that information instead of cubic inches. I am designing progressive dies and usually have in excess of...
  3. rdhdesign

    INSERTING ACTUAL PART SIZE IN BOM

    Can someone tell me if it is possible to retrieve the actual part's dimensions to put in the BOM instead of having to measure them all and insert measurments? MDT 6.0 Thanks Rick Hamlin RDH Design & Detail,
See more

Part and Inventory Search

Back
Top Bottom