Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by RCB

  1. RCB

    Low Temp/Dust Cutting of 1/4" Cu-Ni Plate

    I'm looking for an improvement in our current method of pneumatic driven chisel gun. The copper nickel alloy is fairly soft. It is in an area that has old motor oil close by, thus low heat (note, can't clean up the oil because it is behind the plate we're removing). There are occasional...
  2. RCB

    Low Temp/Dust Cutting of 1/4" Cu-Ni Plate

    I'm looking for an improvement in our current method of pneumatic driven chisel gun. The copper nickel alloy is fairly soft. It is in an area that has old motor oil close by, thus low heat (note, can't clean up the oil because it is behind the plate we're removing). There are occasional...
See more

Part and Inventory Search

Back
Top Bottom