Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by RazorJ

  1. RazorJ

    drilling 304 stainless

    Sorry about the 1" depth...I realized I had forgotten to specify that it was a 1" depth after I had written it. It is a .1285" DIA. drill bit. Could the angle of the bit also be the problem? I'm using a 118 degree bit.
  2. RazorJ

    drilling 304 stainless

    Right now, every thing is manual and done on a drill press which is completley exposed. I will be automating the drill and the entire system will be enclosed.
  3. RazorJ

    drilling 304 stainless

    I am drilling a pilot hole first.
  4. RazorJ

    drilling 304 stainless

    I'm using a Scotchman pure synthetic water soluble sawing coolent with a 5:1 ratio and I am running the drill at 800 RPM
  5. RazorJ

    drilling 304 stainless

    I am drilling a 1" Hole (#30 drill bit) through 304 SS. My problem is bit breakage. My parts, which are being hand drilled, is part of the problem. I would like to know the best style/hardness of drill bit and lubricants to use. Also there has been some debate in my machine shop about the angle...
See more

Part and Inventory Search

Back
Top Bottom