This was an existing system that worked fine. Ver 5.1
Was removed and installed ver 6.0
Anti virus and firewall was disabled during installation.
Windows is XP sp3.
No have not tried to load a previous version.
I have tried running FTview before installing Enterprise and RSLinx, No success.
I...
I have implemented your suggested corrections. The new tech note on this came out last week. However it did not solve my problem.3 tech notes related to this problem and none of them offers a solution.
I have and error upon starting FT View, The specific error message is this. "Cannot connect to add in objet, Name:Application handler, Cause=
800401e4" Then upon clicking ok, the software boots up but without menus and explorer window is empty.
What i have tried
Unistalled, reinstalled FTView...
There is a block to configure for analogue IO for the 170-aai-030. The block is calle ANA_8I I understand what to put in the parameters but I don't understand what value to put in the first parameter called IBS_IN I'm guessing it's the IO mudule position # but am usure of what that is or how to...
Thanks for the info. I did that and the result is the same.
I have the schneider people working on it but the don't seem to know what the solution is. This sucks, I cant print to printers or even to PDF.
Cant print or even preview the print of the ladder logic with this software. The Error popup window comes up with
Error = MDIForm1.frm
Then when closing that popup the software crashes.
Anyone out there ever run into this and how was it solved.
Thanks
Raymond
It seems that every time I start the software an error message comes up. [Error 1706: No valid source could be found for product RsLogix 500 ......]
Also Every time every time RSLinx boots up. RSLogix 500 asks for to insert the CD to install some features. I followed the instructions but this...
When I try to close the program this message commes up.
[O table (special units setups)cannot be closed because it is being processed. Press Ok after closing the IO table and the edit parameters dialog.]
But I don't have these windows openned.
Note that in my project I have 2 plc's. I can...
