Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by raulob72
-
How to tolerance a 4" diameter hole for a sleeve
The tolerance should be at .001 per inch so it coulbe 3.996 minimun,my .02.- raulob72
- Post #4
- Forum: Drafting Standards, GD&T & Tolerance Analysis
