Recent content by ranas1

Hi, im looking information about UL 132 and UL 125 standard, anyone knows about a link or web site where i can download these stadards?? Best regards

Hi,Im looking information about Moist Ammonia Air Stress Cracking Test, i need to realize this test but i need to fabricate the chamber to realizae the test. Anybody knows if a can use acrylic to fabricate the chamber????, or if exit an ASTM standard about this chamber?? or if someone can tell...

Hi Brian835. Thank you so much, the information will be very helpful. Best regards

Hi, I need to calculate the flow rate through a in tank check valve for compressed air, but im not sure how to analize it, im considering to analize like flow through an orifice???, is this accurate??? best regards

Hi, im new in this forum, i would like to know if someone to know if there is a standard ASME for manufacture nozzle and half coupling used in compress tank ??? I have been looking in ASME section VIII div -1 but i have not found a standard for that. Best regard

Thank you a lot for your help. Regards

Hi, Im trying to find information about Bulge Forming Tube With Axial Compressive Force, im considering to use a elastomer to expand the walls. Can anybody tell me a book or link where i can to find information , i would like to calculate the force requiered to deform the tube. Thnak you for...

Hi. MikeHalloran. Thank you your answer. I will try to find literature about this ribs and i will use the plastic forum too. thank. regards

Hi, im looking information about the design of radial and annular ribs ( im working with plastic ) Im trying to calculate the dimetions of ribs. but im confused. Can anybody help??, please. attached an image. best...

Hi, im looking a good trial software used to Hight pressure die casting, Could anybody tell me which will the best?? thank.

Hi, Thanks for helping me out with my problem Yes tbuelna ,i wish to determinate the max. wrenching torque that can be applied with a given head height without damage the hex surface, im working with PPS bolts and nut.

Im triying to calculate the max. torque on hex head bolt and its thickness, im confused. i have had a equation TH= CH*(WAF2)*(WRH)*(UTS)*(NC) CH.- constat =0.103 WAF .- width across flats WRH.- wrenching height UTS.- ultimate tensile strenght NC.- number pair of contact (for hexagon =3) but...

CoryPad (Materials) i dont know if you could help me with a link ???[smile],

Thanks 3DDave, but the link that kindly sent me just talk about the same but doesn´t have a link with the publication [sad].

Hi, im trying to find the creep curve for polymers and zinc and aluminium alloys used in High Pressure Die Casting. Im wondering if someone know or have a link where i can get it, im have been in contact with some suppliers but they dont have the information. best regard