Hi hudson
Thanks for your advise. you are correct. I have this as various scanned curves and trying to make a smooth surface out of those curves. I tried mesh surface, bridge surface but didn't get smooth surface. then i was trying n-surface & section surface options ( swoop, etc.). In that...
Hi nxconsultant
Thanks for your advise. I did try it with mesh surface but as u can see one half is continuous but gap does not bridge smooth enough. that's why i was trying n surface.
Hi guys
I am trying to load the part file but i have been unsucessful in loading the file. it shows it is loading but ends with error.
I have tried after compressing the file but didn't get any better.
I am using NX6. I am trying to use n-surface i m not getting smooth surface. also i tried section surface but i am unable to select spine curve. Can someone please help ?
Can this be because the curves i was trying to do surface are not in single plane ?
Can some advise where i can find...
I am trying to use n-surface i m not getting smooth surface. also i tried section surface but i am unable to select spine curve. Can someone please help ?
Can this be because the curves i was trying to do surface are not in single plane ?
Can some advise where i can find prcatical example...
