Thanks guys, some more questions. How paralleling of linear current sources is done? Just diode to the output of every current source before connecting it to the general output line... is it that easy?
Output voltage of supply can change between 0.5 and 24V, current has to be constant if...
How are current sources made if they have to supply 50A or 500A or more? Are there such things as switchmode constant current sources? Any reading (or links) on this subject would be of great help.
Thanks for help! Primary voltage is 220V and i talk about short circuits on secondary. I think its easyer do detect voltage on secondary because voltage is lower there and more acceptable to IC-s. Relay was considered beacause it makes easyer and faster to recover from short circuits. I also was...
I have 220V 800W toroidal tranformer. Output is 36V. I want to use this for various experiments. I wish that it would be impossible to ruin transformer by accidental short circuit or overcurrent. I think of powering the transformer through relay and wiring some analog circuitry that detects...
I have three microcontroller boards connected between two devices. Data flows through these boards from one device to another. Some calculations and transformations are done with data flow.
I do not go to details as this probably is not important. For testing i used LPT port of PC 1 as sending...
Max speed of Compact Flash (or other memory cards) is hard to define as every manufacturer tryes to make faster cards and so speeds rise rapidly.
Easyest way to make data storage for data aqcuisition system is probably not by Comapct Falsh (as that needs IDE interface) but by some more modern...
Does anyone know why such a strange clock frequency as 14.31818 was used in old PC-s?
This information is not practical value for me. I am just curious.
Raivo
I deicded to experiment a bit with linear CCD-s. I have some Toshiba and NEC sensors and also got datasheets. Still it seems that i need more understanding what all these clock pulses are for. Usually at least 4 different clocks (such as phi1, phi2, RS, BT) must be supplyed and it seems that...
It is almost impossible to get any data about such chips. That chip is probably manufactured for this particular board and data sheets are never released to public. :-(
regards,
Raivo
Usbid deals with out-of-production parts. Look at http://www.usbid.com. Also i think that Xicor is not only solution, as other manufacturers (such as Atmel and Samsung} may make compatible chips.
I once tryed to overclock 8051 from 12 to 16 MHz and another from 16 to 20. I used theese on room temperatures and had no problems. IMHO you may try overclocking if your application is for your own use and you make some strong reliability tests before you decide that it is ok. Also i know that...
Do you know of simple ways to measure low frequency electromagnetic noise in environment? I encountered this problem when designing some basic bioelectric transducers. I understand that sensitivity to such noises can be minimised when using differential amplifiers and 50/60Hz filters but...
As much as i know Lewish is not right here... I browsed old data sheets of uPD765 and WD37C65 floppy disk controllers that were used on AT and XT computers. And found that both of theese are z80 compatible (as datasheet states). Even 100 pin flat packs on pentium motherboards use 8 bits for...
Thanks! Your advice helped me more than simply giving this data sheet. Freetradezone contains almost everything i ever heard about.
Thanks again,
Raivo
