Just wanted to have a second opinion on this. I did some research and found that contral joints in basement walls are provided for every 20 to 30 ft. Is this typical for any thickess of the wall or is there any other better way of determining the spacing based on thickess and other factors...
Cecil123 -
As rapt suggested, it will be really helpful for you if you can start working on actual PT Design before you can actually write a code to automate the design procedure. You can find loads of information about PT design at www.adaptsoft.com, www.cement.org and other related websites...
Design of Post-tensioned floors includes determining the required PT force and any additional rebar required to satisfy the strength and serviceability. The ACI requirements are different than what they are for Reinforced Concrete design. To answer your specific questions, I would like to start...
I am designing a parking structure that uses oneway slab-beam system. I was wondering if I can design the beams with min P/A of 125 ksi and add additional tendons in that portion of the slab which is not considered effective to bump up the P/A to 175 ksi (suggested prestress for parking...
Do we need to provide a closure strip for a typical one-way PT slab to eliminate restraint cracking? The length of the building is about 350 ft. The post tensioning manual suggests to consider two closure strips for slab length between 325 and 400 ft. Does anyone have experience of not having...
pba, I understand your concern. But, you have mistaken the entire purpose of the thread. We are not here to debate about whose good and whose not. I hope you share my concern too. I appreciate you all for sharing your thoughts and experiences and expect to see more of them. Thanks.
Dinosaur and Archeng59 - Thank you for your comments. I have learnt a valuable lesson after quitting my first job due to lack of guidance. In this busy world not everyone has time to answer all your questions. But, you could get what you want by doing some research by yourself, and encouraging...
When I started looking for jobs, I used to spend a lot of time going though the openings available on Job search portals like Yahoo jobs and Monster. But, this didn't really help me a lot. Then I started working things out in a different way. I used to shortlist all the structural consulting...
Thankyou all for your valuable responses. And, to be more specific I am working under a Senior Engineer. But, not always you can find a mentor in the Engineer you are working under. I mean to say that the PE would just answer to your specific questions or sometimes you might not even get an...
I feel that to be a successful Structural Engineer one needs careful planning, continuous learning and valuable guidance from the senior engineers or colleagues. But not all the young engineers have the opportunity to improve ones skills and shine under the guidance of a learned Engineer. So, I...
I am kind of looking for possible ways for designing tilt-up walls. I appreaciate if you all can share your experiences in this area and like what software packages, design handbooks or references you use. Thanks in advance.
Can someone suggest good references for design of embed plates for precast panels to carry reactions from joists and beams in a typical warehouse building. Thanks
