Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by raeven

  1. raeven

    Typical Cut Speed for 0.55mm Stainless Steel

    Hello, Since week I work on Mazak STX510 MKII 2,5kW. I got to cut 2mm stainless steel sheet. When use the parameters from software, the bottom side of cutted part isn`t so good. There is dross, not so much but... Maybe it is possible to get clean surface? I have tried:Focus point: -2 and max gas...
See more

Part and Inventory Search

Back
Top Bottom