Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Radivs
-
Looking for direction: making a detailed 3D form/shell?
I thank you both, Mike & Pat, for the ideas and information. The globe, or another form of relief map, process sounds very much like what I am looking for. A topographical map, in 3D, 3' square, that one could hang on a wall, albeit with some varient to the typical hills and valleys. The...- Radivs
- Post #6
- Forum: Plastics Engineering general discussion
-
Looking for direction: making a detailed 3D form/shell?
Mike, Appreciate the response. As I say, like a Halloween mask, opaque surface, with a range of relief, high to low. The outer surface, like a mask, is all that will be seen, so is what requires the detail. I can see what is possible, yes, but I am trying to evaluate processes, to understand...- Radivs
- Post #3
- Forum: Plastics Engineering general discussion
-
Looking for direction: making a detailed 3D form/shell?
A thousand pardons, as I am not an engineer, but am seeking information regarding plastic manufacturing and the processes available. I have looked elsewhere, but have been unable to find any definitive information, or even those whom might have such information. Tried plastics.com, to no...- Radivs
- Thread
- Replies: 5
- Forum: Plastics Engineering general discussion
