Hello,
I have investigated the subject and after consulting with two independent test houses I can confirm that the number of bolts to be used for calculations is 2 as the value of minimum slip load that has been taken for calculations load occurred only on the surface affected by clamping...
Dear All please can anyone advice?
I have followed the guidelines given in the BS4604:1970 standard to establish coefficient of friction (slip factor) between the surfaces of our interest.
I am confused with regards to the interpretation of the calculation method provided by the standard;
Slip...
Hi can anybody advice on how to calculate required clamping force in bolted joint in order to prevent a cabinet from sliding on inclined surface please??
I have been using few programs but the results I am obtaining differ significantly ;/
Dear all please help!
Can differential cooling resulted from drought affect the straightness of our shaft?
We use shrink fit procedure to assemble the core pack on to the shaft.
Core pack is heated up to 200ºC and then shrunk on to the 10” diameter 110” long steel 28Mn6 shaft. The shafts are...
