Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by qwerty22
-
ASME PG-33 F factor to calculate single openings
I've been reading a lot about the F factor (most of it based on UG-37), but have not found an answer for this. For a large pressure vessel with two 6" circular, integrally reinforced, radial nozzles located in the same longitudinal plane offset radially by 15° can the F factor be applied to the...- qwerty22
- Thread
- Replies: 0
- Forum: Boiler and Pressure Vessel engineering
